Hi All and thank you for the welcome! As for moving the bike on as-is, I'm afraid that ship has sailed..... As stated, the bike has been lying fallow for some 20-odd years and has suffered as a result. Seized front brakes, rusting to the frame and general scruffiness around the motor and running gear. (The RT bodywork is in excellent condition, however). It owes me nothing but I felt it would be worth more as a restored machine rather than as a 'barn find'. Also, some years back, I began stripping down with a view to a full return to RT spec but in my ignorance, ruined the thread on the r/h exhaust stub - so even less attractive to a potential purchaser. So, some work required and I'm old school - I prefer to fix rather than discard. There's no incentive any more to go touring 2-up so I thought a conversion to a single-seat bobber would be a fun thing to get into and would make a nice winter project, as well as making the bike lighter and more manageable for an old man! And I fancy returning to biking as an occasional summer activity, as long as it doesn't rain! (I think I've been watching too many Henry Cole re-runs...... ) So far I've pulled everything out of the frame and am looking at which parts to send off for painting/powder coating and whether to paint the engine casings or polish them. I will be stripping/rebuilding everything except the bottom-end (I hope) and renewing gaskets, seals and bearings as required. Probably a new clutch too, although there was nothing wrong with it when laid up but time may have taken it's toll. I found a work around conversion to take care of the exhaust stubs that, though not cheap, saves a lot of work and removes the problem of regular maintenance of the threads and finned nuts. I plan on keeping the bike as stock (minus the bodywork) and will use as much of the original equipment as possible. Any thoughts or advice would be most welcome as would any recommendations as to parts suppliers/engineering and good quality materials etc. Thanks for reading, keep safe. Rich