Girlcbr125r
-
Posts
10 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Store
Gallery
Community Map
Posts posted by Girlcbr125r
-
-
Best /safest Rear paddock stand and a jack .
Bodgers method ...Two step ladders one either side of bike ...large piece of wood supported by both ladders (6/8 foot fence post ).two sturdy ratchet straps around frame or headstock .raise bike via ratchet straps
this idea is genius, i love it.
-
I hung my GSXR from the ceiling of the garage whilst I changed my forks.
my ceiling is air.....
is there nothing to hold the weight undeneth it...
could i bend it over a beer barrel?
-
i have to replace my forks after getting them all bent up in crash. got replacements, just need advice on how to jack it up/keep it up without it falling on me.
any good homemade diy ideas guys????
-
THANK YOU EVERYBODY FOR ALL YOUR HELP
managed to fix it by adjusting the peg adjuster. all sorted
-
it used to go in to neutral fine though.....
-
Hey everyone. So tightened kickstand and un bent lever and it seems to be ok (not getting stuck)
However..... iv noticed it mere impossible to now find N (neutral) insted of going half up from 1st I have to take it to second and keep trying a half down till it eventually finds it. I noticed this other day when I tried to pull out at lights and was confused to why i was revving and no motion.....sooo embarrassing
Is this also because of the lever being bent?? Thinking it's stopping it from clicking in properly.
-
its been an ongoing issue.....since i dropped bike on that side
will try tighten it and bend out lever.....was thinking same thing but didnt want to bend lever and have it snap off.
-
-
Iv noticed a problem when changing gears on my bike (honda cbr125rw 09). When i down shift, it gets stuck under the kickstand. and dosnt "pop" back up.
I really need help......
does anyone know why its doing this or how to fix it.
please help Thank you.
rasing front of cbr without center stand
in Pitstop
Posted
yh i tried to jack it up but was difficult cos of pipe. i cut a piece of wood though to go round where it was pressing exhaust to keep that safe but after about a mm of weight taken the jack wobbles,