ThePhatomfart Posted March 28, 2017 Posted March 28, 2017 Blasted the engine cases of a cbr400rr, stripped down ready for rebuild, used baking soda on 60psi , wont harm the surface, not bad for 30 year old cases Quote
Mr Fro Posted March 28, 2017 Posted March 28, 2017 Looking good!Are you going to lacquer them or just give them a squirt with ACF? Quote
ThePhatomfart Posted March 28, 2017 Author Posted March 28, 2017 Looking good!Are you going to lacquer them or just give them a squirt with ACF?Yeh , I think the oily rag route is the way to go, by the time Ive done the shell's and rings it will be in a state again Quote
Joeman Posted March 28, 2017 Posted March 28, 2017 You got a proper blasting cabinet or some other clever solution? Quote
ThePhatomfart Posted March 28, 2017 Author Posted March 28, 2017 You got a proper blasting cabinet or some other clever solution?Nah , no cabinet this was done alfresco, once the soda has been blasted it turns to talc, can be used again as a cleaning agent mixed with some citrus powder and water , any residual can just be washed away, cheap too 25kg for £20.It's all bio-degradable Quote
Stu Posted March 28, 2017 Posted March 28, 2017 Looking good spanner I have always wanted to give it a go but never knew if the results would be good! Quote
ThePhatomfart Posted March 28, 2017 Author Posted March 28, 2017 Looking good spanner I have always wanted to give it a go but never knew if the results would be good!Could have done with a smaller jet, this was 3mm . Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.