Bar risers.

[Gorky.shunter]

Hi all. Can anyone help? I am trying to change the bars on my 1989 Suzuki gsx750f. I have got the bar but what size risers can I fit and do they come dedicated to particular bikes, or can I get any ones? Thanks

[megawatt]

Only limits on risers is diameter and the length of your cables.. Bars are normally 7/8", 22mm diameter. Risers aren't specific except either 2 bolt or single bolt fitting to top yoke. A few risers are bike specific only because they bolt to forks.

[Gorky.shunter]

Brilliant megawatt. Thanks for your help

[Tango]

Check these out......http://www.oberon-performance.co.uk/acatalog/Oberon_Motorcycle_Handlebar_risers.html

[megawatt]

If too high or too forward, the bars can also touch the fairing before yoke hits lock stops.

[Gorky.shunter]

Thanks guys. Another question of I may. I have removed the top yoke with the clip ons leaving the inner yoke. Do I need another "flat" top yoke slab or do I use the inner yoke to fit the risers to? Thanks. Gordon

[megawatt]

Have you got pictures of these yokes? Usually have a top yoke and a bottom yoke. Dunno what an inner yoke is.

[BabyD]

Isn’t the inner yoke the yellow bit....

Thank you, thank you.......I’m here all week

[Gorky.shunter]

I will try to get some photos on later. Thanks all

[Gorky.shunter]

Hi again all. I think I have attached a couple of photos. The silver one is the clip ons, the black one is left after I have taken the clip ons off. Is the black one the yoke or do I need a top yoke over it.

[megawatt]

Yes, the black one is the yoke. It clamps the fork tops and the upper steering head bearing. The silver thing just carries the handlebars. Never seen that before.

[megawatt]

You can still use both, as the holes in the black one are very big to take risers.. what diameter are the 4 small holes in the silver thing. It's still gonna be interesting fitting risers as the holes aren't parallel to each other.

[Mr Fro]

Also the silver thing is the wrong way round.

[megawatt]

I did spot that.