Boro Jake
-
Posts
153 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Store
Gallery
Community Map
Everything posted by Boro Jake
-
£90 for two tyres is not a rip off!
-
Did a two mile ride high rpm, rolled back in cut the engine then took the photos
-
seems fine to me? Checked them seem fine to me? http://a2.sphotos.ak.fbcdn.net/hphotos-ak-ash4/380010_2860508225534_1044535061_33104525_1275509292_n.jpg http://a4.sphotos.ak.fbcdn.net/hphotos-ak-snc7/405850_2860518865800_1044535061_33104532_1279509147_n.jpg
-
checked with lads on foc u (fazers owners club) most think its best to run rich dont kno about injected cbrs tho
-
Its a carbed version, runs quite rich, how fazers should run tbh. But its made a difference for the better sounds alot smoother.
-
Fitted one to my fazer to a decatted can, cant believe the difference, increase in low/mid range well worth the money!
-
personally i'd do that myself, depends how confident you are though.
-
new lid ...
Boro Jake replied to bendiazclegg's topic in Clothing, Luggage, Accessories and Security
Theres a few nice agv lids on hein gerrick website in the sale -
wd40's shite, try it with plusgas
-
Would stall if you used throttle and the choke was engaged! have you even checked it yet?
-
I'd walk away, gearbox is probably about to fall out!
-
Its alot if its been poorly maintained, if it has a full service history go for it.
-
Engine keeps cutting off and I'm stuck in the middle of nowh
Boro Jake replied to donhuzayfa's topic in Pitstop
Remove the choke cable and make sure this is fully pushed in then try starting it Choke engaged http://a8.sphotos.ak.fbcdn.net/hphotos-ak-snc7/390382_2721275904813_1044535061_33023241_631682277_n.jpg Disengaged http://a2.sphotos.ak.fbcdn.net/hphotos-ak-snc7/390011_2721273064742_1044535061_33023240_1650216288_n.jpg This will be on the left hand side of ur bike. -
Carbed of fuel injection model?
-
Engine keeps cutting off and I'm stuck in the middle of nowh
Boro Jake replied to donhuzayfa's topic in Pitstop
I'd suggest your chokes the problem, it should goto 3k rpm when activated and stay there -
Firing on limited cylinders, ie inline 4 firing on 3. You'd notice the difference as it wud sound rough
-
Engine keeps cutting off and I'm stuck in the middle of nowh
Boro Jake replied to donhuzayfa's topic in Pitstop
Might be a stupid question but you have checked the chokes not sticking on? Should be on the left hand side of ur bike near the carbs -
something like this i was thinking http://file.seekpart.com/productsimage/2011/10/13/2011101316653298s.jpg so it just fits through the header as a temp measure need help on size/where to loook tho
-
As a bolt was snapped, part of the shaft still remains with thread on however theres not enough room to squeeze a standard nut on there. my question is can you get partly sunk nut that would fit through the header plate and bolt on for a temporary measure? bikes an 03 fzs 600
-
What oil you using? My 125 used to jump out of gear using fully syn switched to semi and it stopped.
-
is it worth it? was thinking of getting my fzs 600 done for hopefully more lower range. Also how much does it cost?
-
no bike gear in my size
Boro Jake replied to tryme's topic in Clothing, Luggage, Accessories and Security
Have you actually tried any on? I found motorcycle clothing fittings to be small in comparison to suites etc -
When u say strip, have u installed new rubbers and put some red grease on them?
-
May be set up for pillion, check your manual everything will be there....
-
Quite fancy one of these for my next bike (if i can find a decent one/colour) seems quite an illusive bike haven't seen many about.